The Texas Department of Transportation is warning commercial drivers that oversized loads striking bridges can damage critical structural components, trigger lane closures and set off lengthy repairs, according to a Nov. 17 article published by the agency.
TxDOT records dozens of bridge strikes each year, but the agency said the actual number is likely much higher because some impacts go unreported or are discovered only during routine inspections. Inspectors identified 30 instances of suspected unreported impact damage in 2025 and another 61 in inspections completed so far in 2026, according to TxDOT, which estimates that about 45 unreported strikes may have occurred in 2025. The Fort Worth area had the most reported strikes last year, with eight.
One structure stands out: the Houston Avenue bridge near Interstate 10 in Houston has been hit six times so far this year and 16 times since January 2025, the agency said.
According to TxDOT, strikes typically occur when a truck or its load exceeds a bridge’s vertical clearance, and the risk increases when drivers fail to follow approved routes or travel without required permits. Vehicles and loads exceeding legal size or weight limits generally need an oversize/overweight permit and an approved route from the Texas Department of Motor Vehicles. When a driver is responsible for a strike, TxDOT can pursue a liability claim to recover taxpayer funds, the agency said.
After a strike is reported, crews first determine the extent of the damage and whether the bridge can safely remain open. “Engineers determine which bridge beams were damaged, the type and extent of the damage, and what repairs are necessary,” said Ryan Eaves, field operations section director in TxDOT’s Bridge Division. “Depending on the severity and location of the impact, TxDOT may close shoulders or additional lanes while crews assess the structure and develop a repair plan.”
Damaged concrete beams may be wrapped in a protective covering of chicken wire and a tarp to keep loose concrete from falling onto traffic until permanent repairs are made. On heavily traveled bridges, repairs often take place at night or on weekends under compressed schedules that can significantly increase costs, according to the agency.
Some TxDOT districts have installed over-height detection systems that warn drivers approaching a bridge with insufficient clearance, including at 19 structures in the Odessa area. For bridges with repeated impacts, the agency may pursue projects to strengthen or replace the structure or increase its clearance. The Houston Avenue bridge is tentatively scheduled for demolition beginning in early 2027, with completion estimated for mid-2028; the rebuilt roadway will run underneath I-10.
TxDOT said knowing a vehicle’s height, securing the proper permits and following approved routes are essential steps for commercial drivers to avoid a costly collision.